Epson TM-L90 Manuel De L'utilisateur page 15

3. Slide the roll paper spacer to the appropriate width, as shown above. You can
use the measurement printed inside the printer, aligning the inside edge of
the spacer with the desired measurement.
Width note:
When you want to set the roll paper
width from 61 mm to 70 mm, break off
by hand the two tabs of the spacer
shown in the illustration. (You can
still also use widths from 38 mm to
60 mm with the spacer with the tabs
broken off.)
4. Insert the screw included with the
spacer into the hole indicated in the
illustration to the right and tighten it.
(Even if you can see two holes, this is
the only one to put the screw in.)
TM-L90 with Peeler User's Manual 11
English
tabs
hole for screw