Epson TM-L90 Manuel De L'utilisateur page 14

English
Using Different Paper Widths
Be sure to set the paper width with the memory switch to match printing to the
print width. (For detailed information on the memory switch, see the TM-L90 with
Peeler Technical Reference Guide.)
Also, do not increase the paper width after you have used a narrower width. For
example, do not use 60 mm {2.36"} and then change to 80 mm {3.15"}.
The reason not to increase the width setting if the printer has ever been used is
that when narrow paper is used, part of the head contacts the platen. Therefore,
when a wider setting is used, part of the head or the cutter blade may be worn out,
which can cause poor printing.
The TM-L90 accommodates 80 mm wide roll paper with no adjustments. For rolls
from 38 mm to 70 mm wide you use the spacer included with the printer. (Rolls
from 71 mm to 79 mm cannot be specified.) If the rolls are from 61 to 70 mm wide,
you break two tabs off the spacer. See the width note on page 11.
1. Insert the roll paper spacer so that the front edge goes through the notch and
down to the shaft, as shown below.
front edge
2. Push the roll paper spacer until you feel it click onto the shaft.
Note:
Check that the roll paper spacer slides smoothly to the left and right.
shaft
10 TM-L90 with Peeler User's Manual
notch
roll paper spacer
inside edge of
the spacer