Alarm Volume; Storing The Device When Not In Use; Troubleshooting - SilverCrest SURF 600 A1 Mode D'emploi Et Consignes De Sécurité

SilverCrest SURF 600 A1
When the alarm goes off it can be stopped by pressing any button. The alarm clock is now activated for
the next day, which is indicated by the illuminated icon
Alternatively you can initiate the SNOOZE function, which is approx. ten minutes, by pressing the multi-
function controller. In between alarms the corresponding symbol
this time, the alarm tone will continue.

Alarm volume

The volume of the alarm tone for waking up with the radio depends on the radio volume previously set.
The alarm tone starts quietly and gets gradually louder. The corresponding icon
flashes on the display (11). If the last radio volume set was level three or lower, the alarm tone will sound
at volume level three. This ensures that the alarm tone sounds at a minimum volume even if the radio
volume was previously set to very quiet.
You cannot adjust the volume for waking up with the buzzer. In this case the time between two sounds
decreases with increasing waking time. The corresponding icon
display (11).

Storing the device when not in use

If you intend on not using the radio alarm clock for a longer period of time, keep it in a cool, dry,
clean place. If you do not wish to use the device for a very long time, if applicable, remove the
back-up battery to avoid leakage.

Troubleshooting

The device will not switch on

Check whether the power cable is plugged into the socket.

Check whether the socket is supplying power.
No radio reception, poor radio reception

Unwind the cable antenna (10) fully and try to better adjust this for optimum reception.

Set the station correctly. Where necessary, start another search.
The time will not set automatically

Unwind the cable antenna (10) fully and try to better adjust this for optimum reception of the radio
signal.
40 - English
(20) or (19) on the display (11).
(20) or
(20) or
(19) is flashing. After
(20) or (19)
(19) flashes on the