Setting Stations Manually; Storing Stations Manually; Finding Stored Stations - SilverCrest SURF 600 A1 Mode D'emploi Et Consignes De Sécurité

SilverCrest SURF 600 A1

Turn the multi-function controller (1) slightly to activate the manual station search. The search icon (14)
will flash during the search. The search always starts at the frequency it was last set. The direction of
the search will change depending on whether you turn the multi-function controller (1) clockwise or
anti-clockwise direction.

Once a station is found, the search icon (14) will light up for approx. ten seconds and the frequency
of the station found will be shown on the display (11). During this time, you can continue the search
by slightly turning the multi-function controller (1). Otherwise, the manual search will end and the
display (11) will change to the time indicator.

Setting stations manually

Alternatively, with the station search, it is also possible to set the station manually. This also enables you to find stations
with a weaker signal. To do this, follow the steps below:
Switch the device "ON" and press the Multi-function controller (1) once.
displayed and you can turn the multi-function controller (1) to set the frequency in increments of 0.1 MHz. Turn it anti-
clockwise to reduce the frequency or clockwise to increase it. Once the end of the frequency band is reached, the
search will continue at the other end of the frequency band.

Storing stations manually

You are able to store 20 stations or frequencies. The display (11) shows the memory positions with "P01"
to "P20". Proceed as follows:

Search for a station you wish to save.

Press and hold the "Set/Memory" button (7) for approx. two seconds until the last memory position
selected is flashing on the display (11).

Select a memory position by turning the multi-function controller (1) and confirm your choice by
pressing the multi-function controller (1). The frequency of the station stored will be shown on the
display (11) for approx. five seconds and the save process is complete.
Please note that memory positions already occupied will be overwritten.

Finding stored stations


To find a station you have previously stored, use the buttons "NEXT/ALARM2" (2) and
"PREV./ALARM1" (8) to select the memory position where your chosen station is stored. The starting
point is always the memory position currently selected. Use the "NEXT/ALARM2" button (2) to select
the next higher memory position and the "PREV./ALARM1" button (8) to select the next lower memory
position. Each time the button is pressed, it will continue to the next memory position.
38 - English
The current frequency will be