Sleep Timer; Setting The Wake-Up Time (Alarm) - SilverCrest SURF 600 A1 Mode D'emploi Et Consignes De Sécurité

SLEEP timer

The SLEEP timer enables you to set a time between five and 120 minutes, after which the radio alarm
clock automatically switches off. The time can be set in increments of five minutes. Proceed as follows:

In active mode, press the "SLEEP" button (4).

Select the time when the device should switch off by turning the multi-function controller (1) and
confirm your choice by pressing the multi-function controller (1). Alternatively, you can also set the
time by pressing the "SLEEP" button repeatedly. Confirm your choice by pressing the multi-function
controller (1).

When the SLEEP timer is active, the corresponding icon

While the SLEEP timer is active, the remaining time can be checked by pressing the "SLEEP" button (4)
once or changed by pressing it several times. It is also possible to change it by turning the multi-
function controller (1).

When the set time is reached, the radio alarm clock will automatically switch off.

Setting the wake-up time (alarm)

It is possible to set two wake-up times (ALARM1 and ALARM2). Ensure the clock is set correctly. The
wake-up time can only be set in the off mode. Switch off the device with the "ON/OFF" button (5) if it is
switched on.
The following describes the setting for "ALARM1". "ALARM2" can be programmed in the same way.
Waking up with the buzzer is the default setting in the delivery state. Please note when waking with radio
always the last set frequency is selected.

Press and hold the "PREV./ALARM1" button (8) for approx. two seconds. The hour indicator will flash
on the display (11).

Now set the required hour by turning the multi-function controller (1). Press the multi-function controller
(1) to confirm your choice. The minute indicator will flash on the display (11).

Now set the required minutes by turning the multi-function controller (1). Press the multi-function
controller (1) to confirm your choice. The required wake-up time is now programmed and also directly
activated. This will be indicated by the corresponding
Pressing the "PREV./ALARM1" button (8) gives you the option of displaying the wake-up time or setting the
alarm clock.
Press once:
Press twice:
Press three times
Press four times
Activate alarm clock/display wake-up time
Wake with buzzer, display indicator "bb"
Wake with radio, frequency will be shown on the display (11).
Switch off alarm clock, display indicator "OFF"
SilverCrest SURF 600 A1
(18) will light up on the display (11).
icon (20) on the display (11).
English - 39