Finishing; Door Removal / Installation; Door Adjustment; Latch Block Housing Adjustment - Napoleon S1 Instructions D'installation Et D'utilisation

18

5.0 FINISHING

5.1

DOOR REMOVAL / INSTALLATION

EN
Ensure to have a firm grip of the door at all times.
NOTE: We recommend having two people perform this installation.
Remove the bottom door hinge retainer by removing the screw, as shown below, then loosen the
A.
top door hinge retainer.
Lift the door up and off of the hinge rod.
B.
Carefully place the door facedown, on a soft surface, to avoid scratching the paint.
C.
Install the door in reverse order.
D.

5.1.1 DOOR ADJUSTMENT

Loosen the two hinge screws to adjust the horizontal (levelling) position of the door.
A.
B. Tighten the two hinge screws after the desired door position has been reached.

5.1.2 LATCH BLOCK HOUSING ADJUSTMENT

Loosen the two screws of the latch block housing.
A.
Shift the latch block housing up or down to suit the desired
B.
handle pitch. (HINT: Shifting the latch block housing up
will result in a lower handle pitch. Shifting the latch block
housing down will result in a higher handle pitch.)
W415-1476 / D / 08.21.18
DOOR HINGE RETAINER
DOOR HINGE RETAINER
OLD HANDLE
PITCH OF HANDLE IN
CLOSED POSITION
HINGE SCREWS
HINGE ROD
NEW HANDLE
LATCH BLOCK
HOUSING