Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.0 finishing
installation
EN
WARNING
!
•
Power supply service must be completed prior to finishing to avoid reconstruction.
•
Heat vents and air openings cannot be covered in any circumstances.
4.1
front glass removal
WARNING
!
•
Glass may be hot. Do not touch glass until cooled.
•
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
•
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
•
Before door is removed, turn the appliance off and wait until appliance is cool to the touch. Doors are heavy
and fragile so handle with care.
Place one hand on the front glass and remove the 2 screws from the top of the appliance (Fig. 4-1).
A.
Carefully lift the glass up and away from the appliance (Fig. 4-2).
B.
4.2
crystal / pebble media installation
note:
The front glass must be removed and the appliance must be mounted in its final location before crystals or
pebbles are installed.
Clean the crystal media with a mild dish soap, rinse thoroughly, and dry
A.
before placing it into the media tray.
If applicable, remove the log set (see "log installation / removal" section).
B.
Place the media tray onto the front of the appliance opening.
C.
Carefully place crystals or pebbles into the bottom tray on the front of the
D.
appliance as illustrated. Apply an even layer from side to side.
Re-secure the front glass.
E.
4.3
log installation / removal
Remove the front glass (see "front glass removal" section).
A.
Remove the log set from inside the appliance. Remove packaging and discard.
B.
Place the log set into the appliance.
C.
Reinstall the front glass.
D.
12
W415-2103 / B / 08.24.20
Fig. 4-1
47.1
Front glass
Fig. 4-2
Publicité
Chapitres
Table des Matières
Dépannage
