Setting Date And Time - YSI Chlorine 900 Mode D'emploi

If the instrument is not able to communicate with the IRiM, a timeout occurs after
approx. 2 minutes. The error E 132 is displayed for approx. 4 seconds. Subsequently,
E 132
the instrument returns to test mode (see also 900 series Data Hub manual).
Store Date
Print Time
After confirming the selection with the [MODE] key the value to be edited will be
2
shown for 2 sec.
Mode
The setting starts with the year (YYYY) followed by the actual value to be edited. The
same applies for month (mm), day (dd), hour (hh) and minutes (mm). Set the minutes
SET
first in steps of 10, press the [!] key to continue setting the minutes in steps of 1.
DATE
YYYY
(2 sec.)
Increase the value by pressing the [MODE] key.
Mode
Decrease the value by pressing [ZERO/TEST] key.
Zero
Test
Proceed to the next value to be edited by pressing [!] key.
!
After setting the minutes and pressing the [!] key the display will show "IS SET" and
the instrument returns to the measurement mode.
setting date and time (24-hour-format)
2
ENGLISH
17