Connecting Electrical Power To The Awning - Dometic PW3500 Instructions De Montage

Connecting electrical power to the awning

➤ Inside the vehicle, press the covers on the counter plates until the two tabs click
into the counter plates (fig. h).
➤ Attach the wall bracket for the remote control at a suitable location inside of the
RV and protected against direct sunlight (fig. i).
8 Connecting electrical power to the
awning
!
WARNING!
• Only a qualified electrician should connect the awning to the
electrical power.
• Wire to a 12 Vg power source with correct polarity that is able to
provide 80 W (fig. k 1, sw = black, rt = red).
• Make sure that the polarity is correct when connecting the awning
motor (fig. k 2, br = brown, bl = blue).
Observe the following installation instructions:
• The selected voltage supply must ensure that the awning is always supplied with
power while in operation (even in the extended state). If this is not the case, the
wind sensor is switched off which presents a safety risk.
• Install the main switch and fuse (15 A) (fig. k 3) included, in the positive cable of
the voltage supply. The main switch is required to switch off the awning if, for
example, an awning tent is being installed or if the vehicle is not being used for a
longer period of time (otherwise the standby consumption can run down the
battery).
• Install the receiver inside the vehicle to protect it from damp and wet.
• Observe the length of the cable between the awning motor and receiver when
choosing a place to install it.
• Do not shorten the antenna cable (fig. k ws).
• Connect the ignition (D+ signal) with the orange cable (fig. k or) on the
receiver. This ensures that the awning cannot be opened when driving along.
• Use a suitable tool (crimping tool) when installing the plug supplied to ensure
that the connection is secure and long-lasting.
• If you would like to fit an awning light (accessory), make sure that the maximum
power consumption is 30 W. Make sure that the polarity is correct when
connecting (fig. k, sw = black, rt = red).
• When connecting the receiver to the voltage supply, adhere to the required
cable cross section:
10
PW3500
EN