Napoleon GL22N Instructions D'installation Et D'opération page 10

10
4.0 FINIShING
4.2 SANd oR GLASS medIA pLACemeNt
EN
Either sand for natural gas models (GL22N, GL28N, GL32N) or glass for propane models (GL22P,
A.
GL28P, GL32P), must be spread evenly over the burner pan with a gradual downward slope toward
the front of the burner pan.
Tear the ember material into small thin pieces and spread evenly on top of the media. Ember material
B.
will only glow when exposed to direct flame.
Note: do Not oVeRFILL. do Not CoVeR the pILot WIth medIA oR emBeRS.
4.1 GRAte INStALLAtIoN
For the best flame performance and least carbon, position the grate as far back as possible.
A.
Secure the heat shield to the back of the burner pan with the 2 supplied screws (for GL22 model
B.
GRATE
only), see Figure 1.
Secure the grate to the burner pan (GL28/GL32 models only) using one supplied screw, see Figure 2.
c.
FIG. 1
GRATE
BURNER PAN
4.3 ChARCoAL LumpS/emBeRS
A.
Sprinkle the charcoal embers around the front and sides of the burner pan, as indicated on the
diagram below.
B.
Place the charcoal lumps on top of the charcoal embers at the front of the media.
Note: do not block air shutter opening with charcoal embers or lumps.
W415-1101 / D / 08.28.18
BURNER PAN
GL22 FRONT VIEW
HEAT SHIELD
CHARCOAL
LUMPS
TOP VIEW
FIG. 2
GL 28 / GL32 TOP VIEW
GRATE
BURNER PAN
GLOWING
EMBERS
CHARCOAL
EMBERS
AIR SHUTTER
(PROPANE
MODELS ONLY)