Napoleon GL22N Instructions D'installation Et D'opération page 8

8
3.2 GAS pIpING ANd BuRNeR pLACemeNt
EN
do Not CoNNeCt eItheR the WALL SWItCh, theRmoStAt oR GAS VALVe to eLeCtRICIty (110
This appliance must be isolated from the gas supply piping system by closing the individual manual shut off
valve during any pressure testing of the gas supply piping system at test pressure equal to or less than ½ psi
(3.5 kPa)
Centre the burner pan and valve assembly in the fireplace
A.
opening, making sure the appliance is at least 1.5" (38.1mm)
from the rear of the fireplace.
Secure the burner to the fireplace floor using the 2 screws
B.
provided.
Install the gas line using piping ½" (12.7mm) in diameter or
c.
greater to provide the full volume of gas to the appliance.
The installation of the gas line must be done to local and / or
National codes.
d. When rigid pipe is used an ANSI approved manual shut off
and a union must be installed upstream within the appliance
cavity.
To ensure the appliance operates reliably, install a sediment
E.
trap upstream of the appliance within the structures of the
piping system.
When using propane, a regulator must be used between the
F.
tank and the outside wall of the house to ensure the line pressure does not exceed 14"(355.6mm) w.c.
inside the house.
Check gas connections with a gas detection device to test for leaks in the system. Soapy water mixture
G.
can also be used to check for leaks.
Once all the gas connections are tested for leaks, start the appliance. Follow the "OPERATING AND
H.
LIGHTING INSTRUCTIONS" section to ensure the appliance is working properly before finishing.
W415-1101 / D / 08.28.18
WARNING
!
VoLtS).
MIN. 1.5"
(38.1mm)
Regulator
Appliance
3" (76.3mm)
SECURING
HOLES/SCREWS
Manual
Shut-Off
Union
Valve
Appliance
Wall
Shut-Off
Key
Sediment
Trap
VALVE
HOUSING
BATTERY
SUPPORT PLATE
(BATTERY CASE
SECURED INSIDE)