DeWalt DW088 Traduction De La Notice D'instructions Originale page 52

EnGLIsH
3. Position the detector so that the sensor window
detector up or down within the approximate area of the beam, until you have centered
the detector. For information about the display window indicators and the audible
signal indicators, refer to the table titled Indicators.
Above Grade
fast beep
1. Use the marking notches
Mounting on a Grade Rod (Fig. F, G)
1. To secure your detector to a grade rod, first attach the detector to the clamp by pushing
in on the clamp latch
detector until the latch
2. Open the jaws of the clamp by turning the clamp knob
3. Position the detector at the height needed and turn the clamp knob clockwise to
secure the clamp on the rod.
4. To make adjustments in height, slightly loosen the clamp, reposition and retighten.
Detector Cleaning and Storage
• Dirt and grease may be removed from the exterior of the detector using a cloth or soft,
non-metallic brush.
• The Dewalt digital laser detector is rain resistant but not immersible. Do not pour water
on the unit or submerge it under water.
• The best storage place is one that is cool and dry—away from direct sunlight and
excess heat or cold.
50
INDICATORS
Slightly Above
Grade On Grade
fast beep steady tone
to accurately mark the position of the laser beam.
20
26 . Slide the tracks 27
29 on the clamp pops into the latch hole
25 is facing the laser beam. Move the
Slightly below
Grade
slow beep
on the clamp around the rail
30
31 counterclockwise.
Below Grade
slow beep
28 on the
on the detector.