DeWalt DW088 Traduction De La Notice D'instructions Originale page 50

EnGLIsH
• Extreme temperature changes cause movement of internal parts that may affect
the accuracy of the tool. Regularly check the accuracy while using the tool under
these circumstances.
• Although the tool corrects small out-of-level errors automatically, when it is bumped,
re-adjustment to balance or set-up may be required.
• If the tool has been dropped or has tipped over, check whether there is damage by
performing the field calibration checks. See Maintenance.
Switching On and Off (Fig. A)
The tool has separate switches to operate the vertical laser line and the horizontal laser line.
• To switch the vertical laser beam
• To switch the horizontal laser beam
• To switch either laser beam off, press the on/off switch again.
Transferring a Position Mark (Fig. D)
The tool produces two laser lines in horizontal and in vertical direction, to transfer a mark.
• Align the relevant laser beam with the mark.
Rotating the Tool (Fig. E)
When in wall set-up, the tool can be rotated manually to transfer the horizontal laser line.
• Rotate the tool to the left or right as required.
Laser Accessories
Digital Laser Detector: DE0892 (Fig. F)
Some laser kits include a DEWALT Digital Laser Detector. The DEWALT Digital Laser Detector
helps in locating a laser beam emitted by the laser in bright light conditions or over long
distances. The detector can be used in both indoor and outdoor situations where it is
difficult to see the laser beam.
The detector is designed exclusively for use with the DW088/DW088CG and the DW089 line
lasers and other compatible D
48
4 on, press the on/off switch
5 on, press the on/off switch
WALT line lasers. It is not for use with rotating lasers.
e
1 .
2 .