Searching A Station Manually: Manual Search - JVC KD-LX30R Manuel D'instructions

Searching a station manually: Manual search

1
2
1
Note:
This receiver has three FM bands (FM1, FM2, FM3). You can use any one of them to listen
to an FM broadcast.
2
3
To tune into
stations of higher
frequencies
To tune into
stations of lower
frequencies
When an FM stereo broadcast is hard to receive:
1 Press MODE BAND while listening to an FM stereo broadcast (the ST indicator lights up
while receiving an FM stereo broadcast).
"MODE" appears on the lower part of the display, and the number buttons can work as
different function buttons.
2 Press MONO (monaural), while "MODE" is still on the display, so that the MO indicator
lights up on the display.
The sound you hear becomes monaural but reception will be improved (the ST indicator
goes off).
Each time you press the button, the MO indicator lights up and goes off alternately.
1-
MONO
MODE BAND
Select the band.
1 Press SOURCE (ATT) to select AM or FM as the source.
2 If necessary, press and hold MODE BAND to select the
FM band number (FM1, FM2 or FM3.)
Press and hold
starts flashing on the display.
Tune into a station you want while "M" is
flashing.
• If you release your finger from the button, the manual mode
will automatically turn off after 5 seconds.
• If you hold down the button, the frequency keeps changing
(in 50 kHz intervals for FM and 9 kHz intervals for AM —
MW/LW) until you release the button.
1-
2 1
¢ or 4
2,3
until "M" (Manual)
7