Dimplex LAK 3IMR Instructions D'installation Et D'utilisation page 48

English
Information requirements for heat pump space heaters and heat pump combination heaters
Model
Air-to-water heat pump
Water-to-water heat pump
Brine-to-water heat pump
Low-temperature heat pump
Equipped with a supplementary heater
Heat pump combination heater
Parameters shall be declared for medium-temperature application, except for low-temperature heat pumps. For low- temperature heat pumps, parameters
shall be declared for low-temperature application.
Parameters shall be declared for average climate conditions:
Item
Rated heat output (*)
Declared capacity for heating foer part load at indoor temperature 20°C and
outdoor temperature Tj
Tj = - 7°C
Tj = + 2°C
Tj = + 7°C
Tj = + 12°C
Tj = bivalent temperature
Tj = operation limit temperature
For air-to-water heat pumps
Tj = -15°C (if TOL < -20°C)
Bivalent temperature
Cycling interval capacity for heating
Degradation co-efficient (**)
Power consumption in modes other than active mode
Off mode
Thermostat-off mode
Standby mode
Crankcase heater mode
Other items
Capacity control
Sound power level, indoors/ outdoors
Emissions of nitrogen oxides
For heat pump combination heater:
Declared load profile
Daily electricity consumption
Contact details
(*) For heat pump space heaters and heat pump combination heaters, the rated output Prated is equal to the design load for heating Pdesignh , and the rated
heat output of a supplementary capacity for heating sup(Tj ).
(**) If Cdh is not determined by measurement nthen the default degradation is Cdh = 0,9
(--) not applicable
EN-22
LAK 9IMR
yes
no
no
no
yes
no
Symbol Value Unit
Prated 4 kW
Pdh
4,4 kW
Pdh
5,1 kW
Pdh
5,4 kW
Pdh
5,4 kW
Pdh
4,2 kW
Pdh
4,2 kW
Pdh
3,9 kW
T -10 °C
biv
Pcych - kW
0,90 -
Cdh
P
0,015 kW
OFF
P
0,020 kW
TO
P
0,015 kW
SB
P kW
0,000
CK
variable
L 42/63 dB
WA
NO
- mg/kWh
x
-
Q
- kWh
elec
Glen Dimplex Deutschland GmbH, Am Goldenen Feld 18, 95326 Kulmbach
452162.66.09 · FD 0007
Item
Seasonal space heating energy
efficiency
Declared coefficient of performance or primary energy ratio for part load at
indoor temperature 20 °C and outdoor temperature Tj
Tj = - 7°C
Tj = + 2°C
Tj = + 7°C
Tj = + 12°C
Tj = bivalent temperature
Tj = operation limit temperature
For air-to-water heat pumps:
Tj = -15°C (if TOL < -20°C)
For air-to-water heat pumps:
Operation limit temperature
Cycling interval efficiency
Heating water operating limit
temperature
Supplementary heater
Rated heat output (*)
Type of energy input
For air-to-water heat pumps: Rated
air flow rate, outdoors
For water-/brine-to-water heat
pumps: Rated brine or water flow
rate, outdoor heat exchanger
Water heating energy efficiency
Daily fuel consumption
LAK 3IMR - LAK 14ITR
Symbol Value Unit
η
112 %
s
COPd
1,81 -
COPd
2,86 -
COPd
3,90 -
COPd
5,93 -
COPd
1,61 -
COPd
1,61 -
COPd
1,29 -
TOL -10 °C
COPcyc - -
WTOL 55 °C
Psup 0 kW
eletrical
- 3600 m³ /h
- -- m³ /h
η - %
wh
Q
- kWh
fuel
www.glendimplex.de