Kimex 164-5070 Manuel D'utilisation page 116

GETDAPAVL
SETDYNAMICBASS
GETDYNAMICBASS
SETBASSGAIN
GETBASSGAIN
SETSURROUNDSOUND
SETEQUSERFREQ
GETEQUSERFREQ
GETDIGITALOUT
SETSOUNDSYSTEM
SETEQMODE
GETEQMODE
SETDIGITALOUT
HARDOFHEARING
AUDIODESC
VOLUMEUP
Get DAP (Dolby Audio
Processing) AVL state.
Set dynamic bass state.
Get dynamic bass state.
Set bass gain
Get bass gain
Set surround sound
state.
Set equalizer user freq.
value for any band.
Get equalizer user freq.
value of specified band
Get digital out.
Set sound system.
Set equalizer mode.
Get equalizer mode
Set digital out.
Set hard of hearing state. integer n (0 = off, 1 = on)
Set audio description
state.
Inrease Volume Level by
1 step
(Until max volume)
English - 31 -
no parameter
integer n (0 = off, 1 = on)
no parameter
integer n (-6 <= n <= 6)
no parameter
integer n (0 = off, 1 = on)
string n (120Hz, 500Hz,
1.5KHz, 5KHz, 10KHz)
integer n -13 < n < 13
Example:
SETEQUSERFREQ 120Hz
10
string n (120Hz, 500Hz,
1.5KHz, 5KHz, 10Khz)
no parameter
string n (M, BG, I, DK, L, LP)
string n (Music, Movie,
Speech, Flat, Classic, User)
no parameter
string n (compressed, pcm)
integer n (0 = off, 1 = on)
no parameter
#*DAP (Dolby Audio Processing
Availability) is inactive
or
#*DAP (Dolby Audio Processing
Availability) Mode is off
or
#*DAP (Dolby Audio Processing)
state is ...
#*set dynamic bass state to n
#*the dynamic bass state is ...
(0 = off, 1= on)
#*set bass gain to n
or
#*Incorrect sound system
parameter entered
#*the bass gain level is n
Note: Above n is -6 <= n <= 6
#*set surround sound state to n
#*setEQUserFreq() set to n
or
#*Invalid parameter entered
or
#*Incorrect equalizer mode. It
should be USER mode
#*the equalizer value for the
band is n
or
#*Invalid parameter entered
Note: Above n is -13 < n < 13
#*digital out is pcm
or
#*digital out is compressed
#*setSoundSystem() to n
or
#*Incorrect sound system
parameter entered
#*setEQMode() set to n
or
#*Incorrect equalizer parameter
entered
#*the equalizer mode is n
Note: Above n is one of Music,
Movie, Speech, Flat, Classic,
User
#*setDigitalOut() set to n
or
#*Incorrect digital out mode
parameter entered
#*set hardofhearing state to n
#*set audio description state to n
#*volume LEVEL is increased
to ...
or
#*Volume level is at max value.
You can not increase volume
level further. Confirmed max
volume level is ...