Kimex 164-5070 Manuel D'utilisation page 103

UART 0
UART 1
Wifi & BT
(Optional)
Menu lock
Auto Source
Switch
Power Up Settings
Power Up Mode
Quick Standy
Power on Delay
Auto Launch
Boot Up Picture
Mode
Select ASCII/HEX protocol for UART 0. Default value is ASCII. There is no need to
restart the Display after selection in order to work with the protocols correctly. If the
selection is changed, the latest selected protocol will be preserved and started when
the Display is booted up.
Note that ASCII/HEX selection is not working while debug logs are enabled. If it is
wrongly changed to HEX while debug logs are enabled, revert the selection to ASCII and
reboot the Display in order to correct the debug logs and the ASCII protocol behaviour.
Also note that HEX protocol will work with the baud rate value 19200 for UART 0.
Select ASCII/HEX protocol for UART 1. Default value is HEX. There is no need to restart
the Display after selection in order to work with the protocols correctly. If the selection
is changed, the latest selected protocol will be preserved and started when the Display
is booted up.
Note that ASCII/HEX selection is always working as expected. It does not matter if the
debug logs are enabled or not.
Also note that HEX protocol will work with the baud rate value 9600 for UART1
Sets the source option for these funtions. Auto, Display and Android options will be
available.
You can block the usage of the menu button on the remote by setting this item as All
menus. When you press the menu button, you will be asked to enter the PIN that
you have defined in the First Time Installation. Set as Off to disable this function.
If this option is enabled the Display will switch to the currently active HDMI source
automatically when a device is connected to the Display through the HDMI1 or
HDMI2 input socket. Set as Enabled to enable this feature.
When the HDMI source is removed the Display will switch to other active HDMI
source. If there isn't any other device connected to the Display and the HDMI Wake
UP option for the related HDMI source is enabled the Display will switch into the
standby mode.
There is also a 3-second restriction for the successive connected HDMI sources.
This means, second HDMI device must be plugged in 3 seconds after the first HDMI
device is plugged in.
Note: This feature applies for HDMI1 and HDMI2 input sockets only. Refer to the
General View section to see the HDMI inputs.
Configures the power up mode preference. Last State, Always On and Standby
options are available.
If this feature is enabled the Display can be turned on again with the RS232 and LAN
commands if it is turned off through it. Press Left or Right button to enable or disable
the feature.
If this feature is enabled the Display can be turned on again with the
Power
RS232 and LAN commands if it is turned off through it. Set to Reactive
Mode
to enable or to Eco to disable the feature.
(*)
(*) If the ERP Regulations 2021 are applied (depends on the model of the unit): Power
Mode option will be available instead of Quick Standby option
Sets a delay value at power on. This value can be set from 0 to 2000 ms in steps of 100
ms. The Display will turn on after the set delay time is expired.
Configures the auto launch preference. CMS(Start url), Open Browser(Open Browser
initial page), Vsign Lite and Disabled options are available.
Configures the picture mode preference at power on. If set as Off the last set picture
mode will be used at power on.
English - 18 -