Controls - HBM MC2A Manuel D'emploi

MC2A
NOTE
This manual apply to MC2A measuring amplifier from Hardware
Version 1.10. The label on the printed circuit board is visible when
the housing cover is opened (see (7) in the following figure).
1

Controls

The controls are accessible after removing the lid of the housing.
Fig. 1.1: Control elements
Notes:
1 A screwdriver type potentiometer P 24 − setting the switching point of the
limit switch.
2 Switch S 22 − Selection of voltage or current output (option).
3 Screwdriver type potentiometer P 21 − Zero balance for amount.
4 Screwdriver type potentiometer P 22 − Zero balance for phase.
5 Screwdriver type potentiometer P 23 − Fine adjustment of meas. range.
6 Switch S 21 − Measuring range adjustment
7 Hardware-Version MC2A
A1974−2.2 en/de/fr
1
2
P24
S22
R58
P21
R26
P22
P23
S21
R44
5
4
6
3
7
7
HBM