ETNA T267 Notice D'utilisation page 73

Worktop cutout
dimensions
Installation procedure
• Cooking hobs can be installed into worktops that are 30 to 50
mm thick.
• The kitchen furniture element underneath the hob should not
be fi tted with a drawer. If the kitchen furniture element as a
horizontal partition wall, it should be installed no less than 60
millimeters from the lower surface of the worktop. The space
between the partition wall and the hob must be empty; no
objects should be placed into that gap.
1 - Fixing bracket
2 - Screw
3 - Hole
• The worktop should be installed completely horizontally.
• The cutoff surfaces should be appropriately protected.
• Use the supplied screws [2] to secure the fi xing brackets [1]
to the bottom of the cooker where appropriate holes [3] have
been prepared for this purpose.
• Insert the cooking hob into he cutoff and press it heavily from
above against the worktop.
• For screwing down the fi xing clip it is not allowed to use
screws longer than 6,5 mm.
• Connect the cooking hob to the power mains (see instructions
for connecting a cooking hob on a power network).
A - Thin worktops
B - Thick worktops
73