Procedure To Clean Heavily Scaled Flake Ice Machines - Manitowoc RF Serie Manuel D'utilisation

Maintenance
Step 10 Refer to Removal of Parts for Cleaning/Sanitizing
and disassemble parts for hand cleaning/sanitizing.
• Hand clean all parts.
• Rinse all parts with clear potable water.
• Sanitize all parts — do not rinse after sanitizing.
• Spray all interior bin surfaces with sanitizer (do not rinse
sanitized areas).
• Spray evaporator discharge spout.
Step 11 Reassemble ice machine.
Step 12 Turn off the ice making water supply.
Step 13 Refer to chart and premix water and sanitizer.
Amount of Water
1 Gallon (4 L) Water
Step 14 Fill the evaporator and reservoir with sanitizer/
water solution.
Step 15 Move the toggle switch to the ON position. The
ice machine will make ice with the sanitizer/water solution
and deposit the ice in the bin. Add the remaining sanitizer/
water solution when the water level in the reservoir drops.
NOTE: Do not allow the sanitizer/water level to drop below
the minimum water level. The ice machine will discontinue
the cleaning cycle if the water float switch opens.
Step 16 After all of the sanitizer/water solution has been
added to the reservoir, turn on the ice making water supply.
Step 17 Continue the freeze cycle for 30 minutes and then
discard all ice produced.
26
Amount of Sanitizer
0.5 ounce (15 ml)
Procedure to Clean Heavily Scaled Flake Ice
Machines
Step 1 Remove front and top covers and set the toggle
switch to the OFF position.
Step 2
Remove all ice from the bin.
Step 3
Turn off the ice making water supply.
Step 4
Remove the top cover from water reservoir.
Step 5
Refer to chart below:
Premix cleaner with lukewarm water in a non-metallic
container.
Water
Model Reservoir
Capacity
RF0244
RNS0244
RF0266
RF0385
14 oz (400 ml)
RNS0385
RF0388
RF0399
RF0644
RFS0300
RNS0300
17 oz (500 ml)
RNS0600
RFS0650
RNS1000
RFS1200 34 oz (1 L)
RF1200
RFS2300
68 oz (2 L)
RF2300
Step 6
Remove all water from the evaporator and water
reservoir. Add the entire cleaner/water solution and re-
install the reservoir cover.
Leave the cleaner/water solution in the evaporator for a
minimum of 4 hours.
Step 7
Remove all cleaner/water from the evaporator
and water reservoir.
Step 8 Follow the standard cleaning and sanitizing
procedures.
Part Number 000007644 Rev 01 12/16
Section 4
Mix Cleaner and Water
Use Metal Safe Ice Machine
Cleaner, part number
000000084 only
Cleaner Water
9 oz (266 ml) 5 oz (148 ml)
11 oz (325 ml) 6 oz (177 ml)
23 oz (680 ml) 11 oz (325 ml)
46 oz (1.3 L) 22 oz (650 ml)