Changing The Batteries; Troubleshooting - Wohler VE 200 Mode D'emploi

10 Changing the
batteries
Fig. 12: Changing the batteries
11

Troubleshooting

Problem
No image
The LED light blinks or does
not shine bright enough.
Does not function normally.
Forgot password.

Change the batteries, when the LED of the
ON/OFF button shines red.

Open the battery compartment

Insert 4 new AA batteries 1,5 V. Observe the
right polarity.
Solution
Check whether the probe is connected to the handle body
correctly.
Replace the batteries. Make sure the polarity is correct.
Replace the batteries.
Shutdown and turn on the device again.
Use a pin to press the reset key for 7 seconds to reset the
settings of the device.
00000000.
The default password is
Changing the
batteries
EN
33