Prior To Inspection; Replacing The Probe; Inserting The Memory Card - Wohler VE 400 Mode D'emploi

Prior to inspection

5 Prior to inspection
5.1

Replacing the probe

Fig. 16: Connecting the probe
5.2 Inserting the memory
card
28
• To remove the probe undo the gland nut, then
disconnect the probe from the monitor.
• To connect the probe to the monitor, insert the
probe into the female connector ensuring the
notch on the male connector is precisely
aligned with the red dot on the female con-
nector.
Then tighten the gland nut finger-tight.
•
NOTE!
Connect the camera probe before switching on
the Wöhler VE 400. If you connect the probe
when the device is switched on, you will need to
restart the Wöhler VE 400.
Switch off the Wöhler VE 400.
•
The memory card slot is located on the bottom of
the device below the black cover
To remove the memory card: Press the card in
•
lightly until it is ejected, then pull out the
memory card.
Always insert the memory card so that the
•
label faces upward (towards the display).
CAUTION!
Never use force when inserting or removing the
memory card.