Before The Inspection; Connecting The Probe; Switch On And Off - Wohler VE 320 Mode D'emploi

Before the inspection

6 Before the inspec-
tion
6.1

Connecting the Probe

Figure 3: Probe Connection
6.2

Switch on and off

28
Loosen the union nut of the probe connection
•
and remove the probe (see fig. 1 part 3)
To assemble the probe again, proceed as
•
follows:
ATTENTION!
The probe connection has a small notch. Take
care to plug the notch on the small nose piece of
the plug connector.
After that tighten the union nut.
•
To switch on/off the Wöhler VE 320, briefly
•
press and hold the ON/OFF button.
NOTE!
Make sure that the probe is connected correctly.
Otherwise a "noise" will appear in the image.
NOTE!
A "noise" in the image may also indicate that the
battery needs to be charged.