Charging The Battery; Inserting The Sd Memory Card; Settings - Wohler VE 320 Mode D'emploi

6.3

Charging the battery

Figure 4: Micro USB charging cable
6.4 Inserting the SD
memory card
Figure 5: Inserting the SD memory card
6.5

Settings

If the Wöhler VE 320 is switched on and the bat-
tery voltage is sufficiant, the ON/OFF-button will
shine blue.
If the battery voltage is low, the ON/OFF-button
will shine red.
To charge the device, connect the USB charg-
•
ing cable to the charging port, see fig. 1, part
6. Connect the other end of the charging cable
to the mains adapter.
During charging, the ON/OFF button flashes red.
When the device is switched on, the battery icon
in the display will be colored when charging is in
process.
ATTENTION!
Make sure the device is powered off before oper-
ating the SD memory card.
Power off the device, open the cover on the
•
backside of the monitor and insert the SD
memory card, see fig. 1, part 6.
ATTENTION!
Please make sure the card is inserted correctly.
NOTE!
It will only be possible to make settings, if the SD
memory card is inserted. The Settings-button and
the M-button will only be active, if the SD memory
card is inserted.
Before the inspection
EN
29