Functions - Wohler VE 200 Mode D'emploi

3.2

Functions

On/Off-key
Switching on the Flash light
Assembling the Probe
Fig. 3: Probe Connection

Press the ON/OFF key to switch the Video
Endoscope on and off.
When the Wöhler VE 200 is switched on, the
ON/OFF LED will shine blue.
If the battery voltage is low, the ON/OFF LED will
shine red.
For an inspection in a dark environment the flash
light should be switched on.

Switch the flash light on and off by pressing
the flash light key.

The probe can be removed for transport and
storage.

Loosen the union nut and remove the probe.

To assemble the probe again, proceed as
follows:
ATTENTION!
The probe connection has a small notch. Take
care to plug the notch on the small nose piece of
the plug connector.

After that tighten the union nut.
Component explanation
EN
27