ABB WaterMaster FET100 Guide Utilisateur page 38

Debitmetre / transmetteur electromagnetique zones dangereuses atex / ukex / lecex zones 2, 21 et 22
Masquer les pouces Voir aussi pour WaterMaster FET100:
Table des Matières

Publicité

WaterMaster FET100
Débitmètre électromagnétique/ transmetteur | Zones dangereuses ATEX/ UKEX/ IECEx, zones 2, 21
Certificate No.:
Date of issue:
Manufacturer:
Additional
manufacturing
locations:
This certificate is issued as verification that a sample(s), representative of production, was assessed and tested and found to comply with the
IEC Standard list below and that the manufacturer's quality system, relating to the Ex products covered by this certificate, was assessed and
found to comply with the IECEx Quality system requirements.This certificate is granted subject to the conditions as set out in IECEx Scheme
Rules, IECEx 02 and Operational Documents as amended
STANDARDS :
The equipment and any acceptable variations to it specified in the schedule of this certificate and the identified documents, was found
to comply with the following standards
IEC 60079-0:2011
Edition:6.0
IEC 60079-15:2010
Edition:4
IEC 60079-31:2013
Edition:2
TEST & ASSESSMENT REPORTS:
A sample(s) of the equipment listed has successfully met the examination and test requirements as recorded in:
Test Reports:
GB/FME/ExTR11.0005/00
GB/FME/ExTR11.0005/03
GB/FME/ExTR11.0005/06
GB/FME/ExTR11.0005/09
GB/FME/ExTR11.0005/12
Quality Assessment Reports:
GB/BAS/QAR08.0001/06
Fig. A.11 Certificat de conformité CEI n° : IECEx FME10.0006X (page 2 sur 3)
36
IECEx FME 10.0006X
2020-06-24
ABB Limited
Oldends Lane
Stonehouse
Gloucestershire
GL5 5DZ
United Kingdom
ABB Engineering (Shanghai) Limited
No 4528, KangXin Road
KangQiao Town
Pudong New District
Shanghai. 201319
China
Explosive atmospheres - Part 0: General requirements
Explosive atmospheres - Part 15: Equipment protection by type of protection "n"
Explosive atmospheres - Part 31: Equipment dust ignition protection by enclosure "t"
This Certificate does not indicate compliance with safety and performance requirements
other than those expressly included in the Standards listed above.
GB/FME/ExTR11.0005/01
GB/FME/ExTR11.0005/04
GB/FME/ExTR11.0005/07
GB/FME/ExTR11.0005/10
GB/FME/QAR10.0007/11
IECEx Certificate
of Conformity
Page 2 of 4
Issue No: 12
GB/FME/ExTR11.0005/02
GB/FME/ExTR11.0005/05
GB/FME/ExTR11.0005/08
GB/FME/ExTR11.0005/11
OI/FET100/ATEX-FR Rév. B

Publicité

Table des Matières
loading

Table des Matières