maniquick THERAPYQUICK Mode D'emploi page 8

manualeTHERAPYQUICKcompl 9-11-2007
GB 4 Operating
4.5 • The belt may be worn comfortably under clothing when the
settings for the treatment program and time have been selected
Special features
and the keypad cover
case that the pushbutton connectors,
off and that the cables are not damaged.
• For ease of use, the TENS unit may be worn on the belt by
attaching it using the clip on its rear.
• If an application is to be repeated, first turn the two intensity
controllers, 15
desired intensity level. The program is repeated with the settings
selected previously.
• Try out different programs to find out which of the preset
program sequences is most suitable.
• Different people experience different levels of effectiveness with
a treatment program. It may be that the feeling of efficacy of a
program will decrease if it has already been used for several
hours at different times.
This may happen because the body has become used to the pulse
intensity or the program sequence set. This may be avoided by
changing the intensity and the program from time to time.
WARNING
Only use the belt when all four pads are attached to the
electrodes to prevent unpleasant electric shocks. Check the
condition of the electrode pads and cables regularly.
4.6
• The unit switches off automatically on expiry of the preset
treatment time of 15, 30 or 60 minutes. The unit can also be
Switching off
switched off manually at any time. In both cases the intensity
the unit
controllers, 15
click into the OFF position and the display goes blank.
WARNING
To prevent unpleasant electric shocks, never remove the
treatment belt
switched on. First turn the two intensity controllers,
and 9 , anti-clockwise until they click into the OFF position
and the display goes blank.
• Leave the pads on the electrodes on the belt. For safe storage,
place the plastic films marked with "on" back on the electrode
pads after each use. This will increase the service life of both
electrodes and pads.
10
15:06 Pagina 6
12 has been closed again. Take care in this
1 and 3 , do not get pulled
and 9 , to the OFF position and then back to the
and 9 , must be turned anti-clockwise until they
4 from the skin whilst the unit is still
15
4.7 Always check the unit and accessories each time before use to
Troubleshooting prevent damage and defects:
1. The battery has sufficient charge and is not corroded.
2. All pads stick fast and centrally to the electrodes. They are not
damaged or dried out.
3. The cables are not damaged and are in good condition.
4. The contact connectors of the cables are properly and firmly
attached to the pushbutton contacts on the belt.
5. The cables fit tightly into the connection sockets on the TENS unit.
The following table may help if a fault occurs despite these
precautions. Please contact your service centre if it is not possible
to remedy a fault in the manner described.
Fault
The unit cannot be
switched on.
The unit can be
switched on but
switches off again
immediately.
The unit is switched
on but is not
generating any
electric pulses.
The unit cannot
switched on although
a new 9 Volt battery
has been inserted.
GB
4 Operating
Cause Remedy
No battery in the device Remplace battery.
or battery spent.
Battery not inserted Insert battery again.
correctly.
Battery spent. Remplace battery.
Cable broken. Remplace cable.
Cable not corrected Connect cable
properly. properly.
Treatment time has Switch unit to OFF
expired. position and switch
back on.
Contact the service
centre.
11