GE RAK180W1 Manuel Du Propriétaire Et Instructions D'installation page 6

NETWORK INSTALLATION ONLY
NOTE: This section is not required unless the thermostats are
networked
Pairing the Thermostat and the Control Card:
In case of Network Installation with online management, the
thermostat and the Control Card must be paired with a Network
Programmer specific to the property before the installation.
Note: Thermostat and Control Card are factory paired.
Thermostat
The thermostat and control card must not be powered during the
pairing procedure - remove batteries from the thermostat and unplug
the control card from the HVAC unit during the pairing procedure.
• Plug one programmer connector into the thermostat;
• Plug the other programmer connector into the control card.
• Push the black button on the programmer.
• The red light on the programmer should turn on and remain
steadily lit.
• If the red light on the programmer is blinking or is not steadily
lit, unplug the programmer from the thermostat and the control
card and repeat the steps above.
• Unplug the programmer from the thermostat and the control card.
6
Network
Programmer
Programmer
Connector
Control
Card
49-5000416 Rev. 1