GE RAK180W1 Manuel Du Propriétaire Et Instructions D'installation page 47

Initiating a Master Reset
If there are reported errors or configuration issues, the
user may master reset the thermostat to its default
parameters.
Procedure:
• Remove the faceplate of the thermostat
• Power down the thermostat by either removing the
batteries or cutting power to the thermostat.
• While the thermostat is powered off, press and hold the
"config" button located on the control board inside the
thermostat.
• Restore power to the thermostat by reinstalling the
battieries.
• Once the screen lights up, release the "config" button.
• If the master reset was successful, the thermostat will
display "12:00",indicating all settings will be reset to
default and the thermostat needs to be re-configured.
Please see "configuring thermostat" in the manual on
page 9.
Contact GE Appliances technical support at
1-844-GE4-PTAC (or 844-434-7822) if the issues are not
resolved.
49-5000416 Rev. 1
Troubleshooting
47