Publicité
Anleitung_BT_EN_20_SPK1:_
GB
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.
1. Technical data
Power supply
230 V ~ 50 Hz
Shots per minute
Staple width
11.2 - 11.4 mm
Staple length
Staple thickness
1.16 - 1.26 mm
Nail length
14 - 16 mm
Nail thickness
1.16 - 1.26 mm
Weight
Totally insulated
Sound pressure level L
pA
Sound power level L
WA
Vibration a
hv
2. Proper use
The electric stapler is designed for stapling and
fastening textiles, leather and wood with the
appropriate staples and nails. The electric stapler is
designed for temporary operation. If operated
continuously, the stapler will become hot and the
increasing heat will reduce its performance. When
hot, interrupt your work and allow the stapler to cool.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
8
22.08.2007
11:22 Uhr
3.
Safety regulations
The corresponding safety information can be found
in the enclosed booklet.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
CAUTION!
For your own safety, use only staples and
nails listed in the directions for use. The use
of staples and nails other than those listed in
20
the directions for use may result in risk of
injury.
Be sure to pull out the power plug whenever
8 - 16 mm
the tool is not being used, each time before
carrying out any maintenance, and whenever
you want to change the staples or nails!
It is important to wear suitable protective
clothing, and particularly safety goggles,
1 kg
when working with the electric stapler/nailer.
II/®
Please follow the safety instructions.
73 dB
86 dB
4. Layout (Fig. 1)
2
4.6 m/s
1 Trigger
2 Trigger catch
3 Stapling controller
4 Magazine slide
5 Magazine
6 Filling level indicator
7 Stapler head
5. Starting up
Inserting the staples (Fig. 2-4)
Pull the power plug
Press the lever (a) on the magazine slide (4)
downwards (Fig. 2).
Pull the magazine slide (4) to the rear as far as
the stop (Fig. 3).
Fill the magazine with staples or nails (Fig. 4).
When you fill the magazine with nails, make sure that
these rest against the left inner side (b) of the
magazine.
Seite 8
Publicité
