Bosch GCM 10 Professional Notice Originale page 42

OBJ_BUCH-1132-001.book Page 42 Thursday, January 28, 2010 10:16 AM
42 | English
Checking and Adjusting the Basic
Adjustment
Before any work on the machine itself, pull
the mains plug.
To ensure precise cuts, the basic adjustment of
the machine must be checked and adjusted as
necessary after intensive use.
A certain level of experience and appropriate
specialty tools are required for this.
A Bosch after-sales service station will handle
this maintenance task quickly and reliably.
Setting the Standard Bevel Angle 33.9°
(Vertical)
– Bring the power tool into the working posi-
tion.
– Turn the saw table 15 to the 0° detent 14.
The lever 13 must be felt to engage in the de-
tent.
– Open clamping lever 30 and completely pull
out the fence extension 22.
– Loosen the clamping lever 32.
– Push the stop bolt 24 completely inside and
swivel the tool arm until the bolt faces
against the stop screw 23.
Checking: (see figure R1)
– Adjust an angle gauge to 33.9° and position
it on the saw table 15.
The leg of the angle gauge must be flush with
the saw blade 5 over the complete length.
Adjusting: (see figure R2)
– Loosen the lock nut of stop screw 23 with
the provided open-end spanner 35 (12 mm).
– Screw the stop screw in or out until the leg
of the angle gauge is flush with the saw blade
over the complete length.
– Retighten the clamping lever 32 again.
– Afterwards, tighten the lock nut of the stop
screw 23 again.
1 609 929 W07 | (28/1/10)
Aligning the Fence
– Bring the machine into the transport posi-
tion.
– Turn the saw table 15 to the 0° detent 14.
The lever 13 must be felt to engage in the de-
tent.
Checking: (see figure S1)
– Adjust an angle gauge to 90° and position it
between the fence 6 and the saw blade 5 on
the saw table 15.
The leg of the angle gauge must be flush with
the fence over the complete length.
Adjusting: (see figure S2)
– Loosen all Allen screws 34 with the Allen key
21 provided.
– Turn the fence 6 until the angle gauge is flush
over the complete length.
– Retighten the screws again.
Transport
Before transporting the power tool, the follow-
ing steps must be carried out:
– Bring the machine into the transport posi-
tion.
– Remove all accessories that cannot be
mounted firmly to the power tool.
If possible, place unused saw blades in an
enclosed container for transport.
– Carry the machine by the transport handle 29
or hold it by the recessed grips 36 on the
sides of the saw table.
The power tool should always be carried by
two persons in order to avoid back injuries.
When transporting the power tool, use only
the transport devices and never use the
protective devices.
Bosch Power Tools