Bosch GCM 10 Professional Notice Originale page 40

OBJ_BUCH-1132-001.book Page 40 Thursday, January 28, 2010 10:16 AM
40 | English
Sawing Profile Strips/Mouldings (Floor and Ceiling Strips)
Profile strips/mouldings can be sawn in two dif-
ferent ways:
– Placed against the fence
– Lying flat on the saw table.
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Settings
Vertical bevel angle
Floor strip/moulding
Inner corner Horizontal mitre
angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
Outer Horizontal mitre
corner angle
Positioning of
workpiece
The finished
workpiece is lo-
cated...
1 609 929 W07 | (28/1/10)
Always make trial cuts with the mitre angle set-
ting first on scrap wood.
Placed
against
the fence
0°
Left side Right side
45° left 45° right
Bottom edge Bottom edge
on saw table on saw table
... to the left of ... to the right
the cut of the cut
45° right 45° left
Bottom edge Bottom edge
on saw table on saw table
... to the right ... to the left of
of the cut the cut
Lying flat
on the
saw table
45°
Left side Right side
0° 0°
Upper edge Bottom edge
against the against the
fence fence
... to the left of ... to the left of
the cut the cut
0° 0°
Bottom edge Upper edge
against the against the
fence fence
... to the right ... to the right
of the cut of the cut
Bosch Power Tools