Bosch GCM 10 Professional Notice Originale page 39

OBJ_BUCH-1132-001.book Page 39 Thursday, January 28, 2010 10:16 AM
Position of the Operator (see figure O)
Do not stand in a line with the saw blade in
front of the machine. Always stand aside of
the saw blade. This protects your body
against possible kickback.
– Keep hands, fingers and arms away from the
rotating saw blade.
– Do not cross your arms when operating the
tool arm.
Permissible Workpiece Dimensions
Maximal workpiece sizes:
Mitre/Bevel Angle
Horizontal Vertical
0° 0°
45° 0°
0° 45° 46 x 105
45° 45°
Minimal workpiece sizes
(= all workpieces that can be clamped left or
right from the saw blade with the provided
quick-action clamp 7):
125 x 40 mm (length x width)
Cutting capacity, max. (0°/0°): 89 mm
Replacing the Insert Plate (see figure P)
The red insert plate 8 can become worn after
long use of the power tool.
Replace defective insert plates.
– Bring the power tool into the working posi-
tion.
– Unscrew screws 46 with the provided Phil-
lips screwdriver 21 and remove the old insert
plate.
– Insert the new insert plate and screw in all
screws 46 again.
– Set the vertical bevel angle to 0° and saw
through the insert plate.
– Afterwards, set the vertical bevel angle to
45° and saw into the cut again.
This procedure achieves that the insert plate
is as close as possible to the teeth of the saw
blade without touching it.
Bosch Power Tools
Sawing
Cutting Off
– Firmly clamp the workpiece as appropriate
– Adjust the requested horizontal and/or verti-
– Switch on the machine.
– Press lever 3 and slowly guide the tool arm
– Saw through the workpiece applying uniform
– Switch off the machine and wait until the
Height x Width
[mm]
– Guide the tool arm slowly upward.
at max. at max.
height width Sawing Workpieces of the Same Length
(see figure Q)
89 x 95 61 x 144
The length stop 47 can be used for easily sawing
89 x 67 61 x 101
workpieces to the same length.
35 x 144
– Move the length stop 47 on the extension bar
42 x 95 30 x 99
Special Workpieces
When sawing curved or round workpieces,
these must be especially secured against slip-
ping. At the cutting line, no gap may exist be-
tween workpiece, fence and saw table.
Provide for special fixtures, if required.
for its dimensions.
cal mitre/bevel angle.
downward by handle 1.
feed.
saw blade has come to a complete stop.
42 toward the saw blade to the desired clear-
ance.
1 609 929 W07 | (28/1/10)
English | 39