Novoferm T100 R-FU 3KW Notice D'utilisation page 22

Programming the control unit
The programming is menu-driven. Carry out
adjustment of the door in accordance with the
scheme. The following page shows the full extent of
the menu.
!
Set the correct motor and brake type before
setting the end positions (menus 78 and 79).
Wrong setting can damage the door.
No door type selected: E01 is displayed.
Brake selection (menu 78)
Brake type A, currentless braking, is applied at the
same time (value=0) or with a delay (1-9) after start
of the motor.
Brake type B, currentless opening, opens at the
same time (value=10) or with a delay (11-19) after
start of the motor.
Drive motor selection (menu 79)
The drive motors are listed on a separate sheet
because new additions are made constantly.
Setting the door end-of-travel positions (menus
30 and 31)
The top and bottom end positions should be set
directly one after the other.
Door motion settings (menus 30 and 31)
Related parameters such as maximum motor speed
and optimum door motion profile are stored for every
motor type.
These settings could be necessary depending
!
on
the door type.
ON period (menu 49)
The ON period set will prevent the drive motor from
getting overheated and thus getting damaged.
RWA (smoke-heat exhaust) function
Set the required door position in menu 55. Connect
fire alarm to J7 and set value 10 in menu 50.
Programming the radio remote control
Please note that each hand transmitter must be
individually programmed. It is possible for up to 30
radio codes to be learned. The required function can
be selected in menu 64.
KeeLoq, 12 Bit Multibit. The first code determines the
type.
Start impulse (menu 60)
Enter the menu and press the button on the hand
transmitter for the START function. As soon as the
code has been learned, the incremental display
flashes five times.
Half-open position of the door (menu 61)
Enter the menu and press the button on the hand
transmitter for the half-open position. As soon as the
code has been learned, the incremental display
flashes five times.
Light function (menu 62)
Enter the menu and press the button on the hand
transmitter for the light function. As soon as the code
has been learned, the incremental display flashes
five times.
Deleting radio codes (menu 63)
To delete all the learned codes in the menu, press the
oval button and keep it pressed for 5 seconds.
Selection of the transmitter mode (menu 64)
In addition, the transmitters taught in this menu can
temporarily be blocked in this menu.
GB