IDC MIKRO ic Mode D'emploi page 46

C L E A N I N G A N D M A I N T E N A N C E
To remove the collet:
▷ Apply the black spindle wrench [5] over the col-
E N
let.
Fig. 15
▷ Insert a milling tool into the open collet.
▷ Using the spindle wrench, unscrew the collet out
of the spindle.
Fig. 16
46
5
1.
2.
▷ Clean the collet holder using the felt cone [3].
The collet holder must be free of shavings/chips
and debris.
3
Fig. 17
▷ Clean the inside of the collet with the fine collet
brush [2].
Fig. 18
NOTE:
Only use the provided collet grease for lubrica-
tion of the collet cone. Do not use other types of
grease.
▷ Apply a light coat of the collet grease ([1] in
Fig. 14 on page 45) from the service set to the
outer cone of the collet.
This improves the sliding properties and
increases the clamping force of the collet.
1.
2.
2