Application And Operation; Function Of The Buttons - IDC MIKRO ic Mode D'emploi

▷ Insert the standard tools into the blank holder.
Position the tool shank facing toward the out-
side.
▪ Cutter 1.8 is in the spindle.
▪ Set cutter 1.4 to position "2 A".
▪ Set cutter 1.0 to position "3 A".
▪ Set cutter 0.4 to position "4 A".
▷ Optionally: Insert the sister tools into the blank
holder. Position the tool shank facing toward
the outside.
▪ Set cutter 1.8 to position "1 B".
▪ Set cutter 1.4 to position "2 B".
▪ Set cutter 1.0 to position "3 B".
▪ Set cutter 0.4 to position "4 B".
▷ Insert the selected blank into the blank holder.
2.
Fig. 9 Inserting a blank
▷ Tighten the screws with the Allen key provided.
After re-positioning the milling machine, it
is necessary to check the system axes.
To check the axis system:
▷ With the door shut, select the
tion
function at the operational display.
▷ Follow the instructions on the display.
A P P L I C A T I O N A N D O P E R A T I O N
6
Danger from shavings/chips or tool fragments
being thrown from the machine!
▷ Make sure that the door of the milling machine
is always closed during processing!
6.1
Fig. 10
Key
Operation
button [A]
1.
Service
button [B]
Service/Calibra-
Tab. 2

Application and Operation

WARNING:

Function of the buttons

A
B
Buttons
Door shut
Starts or stops the
reference run;
starts or stops the
current program;
activates or deac-
tivates the control
position; activates
the change posi-
tion for the blank
holder
Interrupts the cur-
rent program; acti-
vates the service
position; activates
the tool-changing
position; starts a
cleaning run of the
inspection window
E N
Door open
Activates or
deactivates
the extrac-
tion system
Activates or
deactivates
the sealing
air
39