Moving The Service Position; Moving To The Change Position For The Blank Holder; Changing The Blank Holder - IDC MIKRO ic Mode D'emploi

6.5

Moving the service position

The service position can be moved to from the
starting position or from an interrupted program.
▷ Briefly press service button [B].
The current tool is placed down and the spindle
returns to the service position. The spindle is
released; the motor is blocked. While travelling,
operation button [A] is lit; after reaching the
position, it flashes.
To exit the service position:
▷ Briefly press operation button [A].
The tool is picked up again. The spindle travels
back to the starting position or to the position,
where the program was interrupted. While trav-
elling, operation button [A] is lit; after reaching
the position, it flashes.
6.6 Moving to the change position for
the blank holder
The change position for the blank holder can only
be moved to from the starting position.
▷ Push and hold operation button [A] for at least
three seconds.
The current tool is placed down. The blank
holder is turned in such a manner that the fas-
tening screw becomes accessible. While travel-
ling, operation button [A] is lit; after reaching
the position, it flashes.
To exit the change position for the blank holder:
▷ Briefly press operation button [A].
The machine moves to the starting position.
6.7

Changing the blank holder

In delivery condition, the milling machine is
equipped with the grinding blank holder. For
processing varying materials, it may be required
to use a different blank holder.
A P P L I C A T I O N A N D O P E R A T I O N
To change the blank holder:
▷ With the door shut, select the
holder
function at the operational display.
The current tool is placed down. The blank
holder moves to the change position.
Fig. 11 Change position of the blank holder
1 Fastening screw for blank holder
▷ Loosen fastening screw [1].
▷ Pull off the blank holder toward the right.
▷ Clean the locating bore and surfaces.
▷ Check the pin on the blank holder to be mounted
and clean, if required.
▷ Slide the blank holder to be mounted with the
pin to the stop in the locating bore.
NOTE:
Inaccurate working results or damage to the
blank holder possible!
▷ Tighten fastening screw [1] only with the sup-
plied torque wrench.
▷ Tighten fastening screw [1] with the supplied
torque wrench.
Change blank
1
41
E N