Reference Run; Program Execution; Checking The Workpiece During A Running Program - IDC MIKRO ic Mode D'emploi

A P P L I C A T I O N A N D O P E R A T I O N
Instead of with the buttons, these func-
tions can also be actuated via the software
E N
(see instructions of the milling machine
software).
6.2

Reference run

After switching on, a reference run must be car-
ried out to determine the mechanical zero points.
Operation button [A] flashes.
To start the reference run:
▷ Briefly press operation button [A].
The reference run is started. Operation button
[A] lights up.
The reference run can be stopped:
▷ Briefly press operation button [A].
The reference run is stopped. Operation button
[A] flashes.
To continue the reference run:
▷ Briefly press operation button [A].
The reference run is continued at the position
where it was stopped. Operation button [A]
lights up.
On completion of the reference run, the machine
returns to the starting position. Operation button
[A] goes out.
6.3

Program execution

Before executing a program, it must first be
loaded (see CAM software).
▷ Briefly press operation button [A].
The program is started. Operation button [A]
lights up.
The program can be stopped:
▷ Briefly press operation button [A] or service
button [B].
-or-
40
▷ Open the door.
The program is interrupted. Operation button
[A] flashes.
To continue the program:
▷ With the door closed, briefly press operation
button [A].
The program is continued at the position where
it was stopped. Operation button [A] lights up.
On completion of the program, the machine
returns to the starting position. Operation button
[A] goes out.
6.4 Checking the workpiece during a
running program
▷ Push and hold operation button [A] for at least
three seconds.
The program is interrupted. The spindle returns
to the rear, the current tool is placed down and
the workpiece is turned around. While travel-
ling, operation button [A] is lit; after reaching
the position, it flashes.
▷ Visually check the workpiece.
▷ Briefly press operation button [A].
The tool is picked up again. The spindle travels
to the position, where the program was inter-
rupted. While travelling, operation button [A] is
lit; after reaching the position, it flashes.
▷ Briefly press operation button [A].
The program is continued. Operation button [A]
lights up.