Repeater; Resetting The Timer Control - Renson Cube Manuel

After being activated, the display of the timer control displays 8:8:8, then it turns blank again.
Pressing button 3 will automatically start the timer (default 30 min).
Button 1 can be used to increase the time interval with 5 minutes each time.
Pressing button 3 for a second time will stop the timer (OFF appears on the display).
• Pressing button 1 or 2 shows the last set time interval (if not yet active) but
the timer will not start
• Use button 1 or 2 to increase or decrease the time interval per 5 minutes
• The set timer time will now be saved
• Pressing button 3 will start the timer.
Pressing button 3 for a second time will stop the timer.
• If no button is pushed for 10 seconds, the display will go blank
• While the timer is active it is still possible to adjust the time by button 1 and 2
• 'E01' appears on the display if the connection with the main control fails (see section
9.1.3.3.4 'Connect remotes').
9.2.4 • Repeater
9.2.5 • Resetting the Timer control
Resetting the Timer control will set the timer default at 00:30 min again.
• Hold the button at the back of the Timer control for 10 sec until 8:8:8 appears on the display
• The Timer Control cannot be active during the reset process
Setting a control as a repeater can be useful if the other control
is located too far from the ventilation system. In such a case it is
possible that the signal generated by that control does not reach
the fan. The signal will then be passed on to the other control
located closer to the fan which will repeat the signal and pass it
on to the fan.
• Shortly press the button on the back of the Timer control
• The repeater function is active when
the display indicates 'rt:1'
• The repeater function is inactive when
the display indicates 'rt:0'
Cube
®
EN
139