Turn The Appliance On; General Operating Indications; Cup/Espresso Cup Height Adjustment - Caffitaly System Flexicup M29H Mode D'emploi

• Fill the tank with fresh, non-carbonated water (Fig.4).
• Plug the appliance in (Fig. 13); the appliance switches on.
• Buttons A-B-C-D blink simultaneously; the machine is heating up. When the buttons light
up steady, the appliance is ready to use.
DESCALING SIGNAL:
• When indicator light E blinks YELLOW, it is advisable to do the descaling cycle (see the
section Descaling).
HEATING UP:
• Buttons A-B-C-D blink simultaneously.
WHEN THE WATER FINISHES DURING OPERATION:
• The water tank is empty when indicator light E blinks RED and the machine beeps 3 times
followed by a single intermittent beep.
• Fill the water tank with fresh non-carbonated water (Fig.4).
• Press one of the buttons A-B-C-D. Wait for the machine to complete the water circuit
fi lling cycle.
• When buttons A-B-C-D light up steady, the machine is ready to use.
IF THE LEVER IS RAISED DURING DISPENSING:
• Raising the lever when dispensing a product (Fig.1) can cause sprays of hot water.
Danger of scalding!
• Indicator light E blinks RED and the machine beeps intermittently. Dispensing is
immediately stopped.
• Close the lever (Fig.3).
• Press one of the buttons A-B-C-D to reset the alarm.
• The machine is ready to use again.

Cup/espresso cup height adjustment

• The machine can be adjusted for using large cups or espresso cups.
• The machine is initially set for the use of large cups (Fig.7).
• For best results when using espresso cups, lift and turn the grille on top of the drip-tray
(Fig.10).
• An espresso cup can now be placed under the coffee dispenser (Fig.8).
• If using large glasses, the drip-tray must be removed (Fig.14).
• A large glass can now be placed under the coffee dispenser (Fig.15).
English

Turn the appliance on

General operating indications

19