Before Using Your Device For The First Time; Setting The Clock; Making Coffee; Preparations - CASO DESIGN Coffee Taste & Style 1846 Mode D'emploi

13.2 Before using your device for the first time

Operate the device with only 1,5 litres of water (without paper filter and without coffee
ground), as described in "quick start". Clean the device afterwards.

13.3 Setting the clock

Plug in the device. Press Prog button and CLOCK lights up.
Use the H button to set the hours and the Min button to set the minutes.
The setting is validated automatically.

13.4 Making Coffee

Warning
► Warning symbol: hot steam.
► Caution hot steam can escape at device. Risk of burns.
13.4.1

Preparations

Fill desired quantity of water into the watertank.
Check that filterholder is placed.
Insert the permanent filter into the filterholder or fold the bottom of a paper filter with 1x4
size and insert it into the filter holder. Fill desired amount of ground coffee into the filter.
► Do not fill to much ground coffee into the filter,otherwise the coffee grounds could
overflow.
Close the lid of the device. Place the coffee pot on the warming plate below the drip stop.
Plug in the mains plug.
13.4.2

Selection of strength of flavour

With Mode button you can select desired strength of flavour of the brewed coffee (
medium,
ground. The selected strength of flavour will be saved.
13.4.3

Quick start

Finish the „preparations".
Press On/Off button, the red LED lights up and the device starts the brewing process with
already selected strength of flavour.
The device keeps the coffee warm for 35 minutes after brewing and switches off
afterwards. The red LED lights up during keep warm. If you want to stop the keep warm
function then press On/Off button until the red and white LED will switch off.
► The device is stopped when neither the red nor the white LED light up.
Please note
strong . The flavour depends on the swelling time of the coffee
)
Please note
mild,
32