Display And Panel; Making Coffee; Before First Use; Setting The Clock - CASO DESIGN Hot Brew Manuel D'utilisation Original

Warning
► Do not leave the device unsupervised when it is in operation, so that you can intervene
quickly in the event of dangers.
► Operate the device only with placed filter holder.
► Only operate the device with the lid of the coffee pot closed.

4.1 Display and Panel

Knob: Setting the hours and minutes for the clock and timer
Setting of clock, timer and aroma strength
On / Off / cancel button

4.2 Making Coffee

Warning
► Warning symbol: hot steam.
► Caution hot steam can escape at device. Risk of burns.
4.2.1

Before first use

Clean the device as described under "Cleaning and Maintenance".
Fill the water tank up to the top mark. Place the permanent filter in the filter holder. Continue
without ground coffee. Close the lid of the device. Place the coffee pot on the warmingplate
under the drip protection. Insert the power plug.
"12:00" is shown on the display. Now carry out a brewing process without ground coffee to
clean the device. To do this, press the
device starts the brewing process. When the brewing process is complete, "KEEP WARM" is
displayed.
Switch off the keep warm function with the
cool down. You can now use the device as desired.
4.2.2

Setting the clock

Press button The display shows CLOCK.
When the hour digits are flashing, turn the knob to set the hours. Then wait 3 seconds until the
device switches to the minute display.
When the minute digits start to flash, turn the knob to set the minute. W ait briefly (approx. 5
seconds) until the device saves the setting.
button. The red dot in the display lights up and the
button. Pour the water away. Let the device
11