Preparations; Aroma Plus Function; Quick Start - CASO DESIGN Hot Brew Manuel D'utilisation Original

4.2.3

Preparations

1. Fill desired quantity of water into the watertank, depending on how many cups of coffee you
want to prepare. Check that filter holder is placed. Insert the permanent filter into the filter
holder or fold the bottom of a paper filter with 1x4 size and insert it into the filter holder.
2. Fill desired amount of ground coffee into the filter.
Please note
► Do not fill to much ground coffee into the filter,otherwise the coffee grounds could overflow.
3. Close the lid of the device. Place the coffee pot on the plate below the drip stop.
4.2.4

Aroma Plus function

Activate the Aroma Plus function for more intense taste. For that hold the
is displayed. The selected aroma intensity is safed.
Deactivating aroma mode: Press and hold the button
Please note
► It is not possible to change the aroma setting if the brewing process has already started.
► If you pull the mains plug, your settings (including the activation of the aroma strength) will
be deleted.
4.2.5

Quick start

1. Complete the "Preparations".
2. Start the brewing process: press the button
starts the brewing process with the previously set aroma strength.
3. Keep warm mode: When the brewing process is finished, "KEEP WARM is displayed. The
warming plate is heated for another 35 minutes to keep the coffee warm and then switches
off automatically.
Please note
► The device shows "KEEP WARM" and the minutes that the device is in the keep warm
mode. The time can be displayed by pressing the button
► The red LED and KEEP WARM light up during the holding process. To end the keep warm
process, press the button
► You can stop the brewing process at any time with the button
switches off.
► Do not fill hot water into the watertank.
► Never fill the water tank beyond top mark
, the red LED lights up and the device
. The red LED and KEEP WARM switch off.
button until
until the display
.
. Then the red LED
switches off.
12