Before First Use; Setting The Clock; Preparations; Aroma Plus Function - CASO DESIGN Selection C 12 Mode D'emploi

13.2.1

Before first use

Clean the device as described under "Cleaning and Maintenance".
Fill the water tank up to the top mark.
Place the permanent filter in the filter holder. Continue without ground coffee.
Close the lid of the device. Place the coffee pot on the warmingplate under the drip
protection. Insert the power plug.
"12:00" is shown on the display. Now carry out a brewing process without ground coffee to
clean the device. To do this, press the
and the device starts the brewing process. When the brewing process is complete, "KEEP
WARM is displayed.
Switch off the keep warm function with the
Pour the water away. Let the device cool down. You can now use the device as desired.
13.2.2

Setting the clock

Press button
When the hour digits are flashing, turn the knob to set the hours. Then wait 3 seconds until
the device switches to the minute display.
When the minute digits start to flash, turn the knob to set the minute. Wait briefly (approx.
5 seconds) until the device saves the setting
13.2.3

Preparations

1. Fill desired quantity of water into the watertank, depending on how many cups of
coffee you want to prepare.
2. Check that filterholder is placed. Insert the permanent filter into the filterholder or
fold the bottom of a paper filter with 1x4 size and insert it into the filter holder. Fill
desired amount of ground coffee into the filter.
3. Fill desired amount of ground coffee into the filter.
► Do not fill to much ground coffee into the filter,otherwise the coffee grounds could
overflow.
4. Close the lid of the device. Place the coffee pot on the plate below the drip stop.
13.2.1

Aroma Plus function

Activate the Aroma Plus function for more intense taste. For that hold the
until is displayed.
The selected aroma intensity is safed.
- The display shows CLOCK.
Please note
button. The red dot in the display lights up
button.
button
33