Battery Information; Low Battery - Automate D9857A Mode D'emploi

Battery Information

The Responder LED remote control is powered by an internal
rechargeable battery that can be serviced only through an au-
thorized Directed dealer. The information and precautions in this
section can help maximize your battery's life and usage in provid-
ing your Responder LED remote control with many years of trouble
free operation.
To charge the battery, connect the provided USB cable between
the remote control and a computer with a USB port. The LED flash-
es to indicate the remote control is charging. Once full the transmit
LED will flash once every two seconds.
Warnings! NEVER use a cable other than the one pro-
vided or plug into an unspecified source. Injury, severe
damage or explosion may occur when connected to
any other products or used in a way not intended.
Charging the battery when the temperature is below
32°F (0°C) or above 113°F (45°C) may cause
severe battery damage and/or reduce battery life.
Avoid placing the remote control in areas exposed to
extreme cold or heat (direct sunlight) when charging
the battery.

Low Battery

The remote controls constantly monitor the battery's voltage level.
If low, a low voltage alert is confirmed by LED and/or tones. The
systems siren/horn will also emit one extra chirp after disarming to
alert of a low battery level condition.
To check the battery level, press the
turn on, bottom to top to indicate the current battery charge.
10
button five times. The LEDs
© 2017 Directed. All rights reserved.