Automate D9857A Mode D'emploi page 11

Manual Valet Modes
Use the following routine to manually turn on/off the Valet Modes,
turning both on manually achieves Combo Valet:
1. Turn the ignition ON and then OFF.
• Alarm/System Valet:
Press and release the Valet button once.
Alarm Valet will turn on/off accordingly. The Control Center
LED will be on while Alarm Valet is on and will be off when
Alarm Valet is off. The siren/horn also sounds to confirm.
If your product has System Valet: Along with the Control
Center LED being on, the parking lights will flash nine times
in rapid succession when turned on, and nine times in slow
succession when turned off.
• Start Valet:
Press and hold the Valet button for five seconds.
The parking lights flash nine times in rapid succession when
turned on, and nine times in slow succession when turned
off. The 2-way remote control confirms by using LED and
tones.
Emergency Override
The following procedure Disarms the system when a programmed
remote is not available. Number of presses__________
Turn the ignition ON.
1.
Press the Valet button the correct number of times (the default
2.
is 1 press). After a few seconds the siren output ceases and
the system is Disarmed.
© 2017 Directed. All rights reserved.
9