Monitoring Sound With Headphones; Quitting The System - Pioneer XDJ-RX Mode D'emploi

Masquer les pouces Voir aussi pour XDJ-RX:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6 Turn the [MASTER LEVEL] control clockwise.
Sound is output from the speakers.
The master level indicator lights.
Adjust the [MASTER LEVEL] control so that the orange indicator lights
where the track's volume is highest (at the climax, etc.).
Adjust the master level indicator (red color) to ensure that it does not
light, or the sound could be distorted.

Monitoring sound with headphones

1 Connect headphones to the [PHONES] terminal.
Connecting the input/output terminals (p. 10 )
2 Press the [CUE (CH1)] or [CUE (CH2)] button.
Select the channel you want to monitor.
This operation is not necessary to monitor the sound output from
the [MASTER1] and [MASTER2] terminals (the sound of the master
channel).
3 Turn the [HEADPHONES MIXING] control.
— When turned counterclockwise: The volume of [CH1] and [CH 2]
becomes relatively louder.
— At the center position: The volume of the [CH1] and [CH 2]
sound is the same as the volume of the sound output from the
[MASTER1] and [MASTER2] terminals (the sound of the master
channel).
— When turned clockwise: The volume of the sound output from the
[MASTER1] and [MASTER2] terminals (the sound of the master
channel) becomes relatively louder.
4 Turn the [HEADPHONES LEVEL] control.
Sound is output from the headphones.
When the [CUE (CH1)] button or [CUE (CH2)] button is pressed
again, monitoring is canceled.
Monitoring of the sound output from the [MASTER1] and
[MASTER2] terminals (the sound of the master channel) cannot be
canceled.

Quitting the system

1 Press the [
(PLAY/PAUSE)] button.
Playback is paused.
2 Press the [USB STOP] button for over 2 seconds.
Do not disconnect the USB device or turn off this unit's power while the
USB indicator is lit or flashing. Doing so could delete this unit's manage-
ment data and damage the USB device, making it impossible to read.
3 Disconnect the USB device.
4 Close the cover of the USB device insertion slot.
5 Press the [ ] switch.
This unit's power turns off.
14
En

Publicité

Table des Matières
loading

Table des Matières