KitchenAid 2258066A Guide D'installation page 8

2. To remove the drawer front, pull the drawer front forward and
away from the drawer.
A
A. Drawer front
3. Repeat the process for the other drawer.
Install the Custom Overlay Panels
1. Place the custom overlay panel face down on a clean, flat
working surface.
2. Place the drawer front face down on the overlay panel. Align
all edges of the drawer front to the overlay panel.
3. Using masking tape, secure the drawer front to the overlay
panel.
4. Using the pre-drilled holes in the drawer front as a guide, drill
six ¹⁄₈" x ¹⁄₂" (3.18 mm x 12.7 mm) deep holes into the overlay
panel.
NOTE: Be sure not to drill deeper than ¹⁄₂" (12.7 mm).
A
A. Pre-drilled screw locations
8
A
A
5. Drive six #8 x ¹⁄₂" pan-head screws through the drawer front
into the overlay panel.
6. Repeat the process for the other drawer front.
Reinstall the Drawer Fronts
1. Be sure that the overlay panel is flush with the drawer front as
shown.
Top Drawer
A
B
2. Reinstall the drawer front using three screws across the
A
bottom and two screws on each side of the drawer. See
"Remove the Drawer Fronts."
3. Repeat the process for the other drawer.
Reinstall the Gaskets
1. To reinstall the gasket, place the gasket over the drawer.
2. Start at the corners, and working toward the opposite corner,
press the gasket back into the groove. Be sure to seat the
gasket on all four sides.
3. Repeat the process for the other drawer.
Reinstall the Drawers
1. Install the drawer by fully extending the drawer slides.
2. Place the drawer onto the top of the slides. Push the drawer
all the way back until it locks into place. Then pull the drawer
forward and adjust the slides until the screw holes align with
the drawer.
Bottom Drawer
A
B
A. Drawer front
B. Overlay panel