Zehnder CO2 Sensor Manuel D'installation page 43

With an active pairing mode on a
ventilation unit, there is
10 minutes to pair one CO
Sensor. For each additional
CO Sensor to be paired, the
2
ventilation unit must be put into
active pairing mode again.
2. Press the operating button for 5
seconds to activate the menu.
1. The three LEDs on the right blink
green 3 times.
2. The CO LED blinks green.
2
3. The bottom LED on the right flashes
red and the CO
to indicate the RF pairing option.
3. Press the operating button for
5 seconds to confirm the RF link
selection.
■ The three LEDs on the right blink red
3 times to confirm activation of the
RF link.
4. Briefly press the operating button and
select one of the desired parings:
■ The bottom LED on the right turns
red: this is the standard pairing
mode. The CO
the RF address of the ventilation
unit. Previously registered units
remain active.
■ The middle LED turns red: this is
the pairing mode to register an
additional ventilation unit to the
CO Sensor. The ventilation unit
2
takes over the RF address of the
CO Sensor. Previously registered
2
units must then be paired again in
standard pairing mode.
Only use the pairing method
described below if a new RF
address must be assigned to the
ventilation unit.
2
LED flashes green
2
Sensor takes over
2
■ The top LED turns red: this is the
pairing mode to generate a new
RF address for the ventilation unit.
Previously registered units must
then be paired again in standard
pairing mode.
5. After the above selection, press the
operating button for 5 seconds to
confirm the selection. After this, the
pairing between the CO
the ventilation unit starts.
1. The CO LED flashes orange, and
2
the selected pairing mode LED
flashes red. The ventilation unit is
being sought. This may take some
time.
2. The CO LED flashes orange and
2
the selected pairing mode LED
flashes green. Previously paired CO
Sensors are being sought. This may
take some time.
3. The pairing worked: The three
LEDs on the right blink green 3
times.
4. The pairing failed: The three LEDs
on the right blink red 3 times.
6. Repeat the full procedure for pairing
the next CO Sensor, including
2
resetting the ventilation unit to active
pairing mode.
Pairing a CO
1 minute.
If the pairing has failed, try pairing
the CO Sensor by holding it
2
closer to the ventilation unit.
Sensor and
2
Sensor usually takes
2
EN - 43
2