Start Screen; Basic Settings; View Results - Herth+Buss CrankPrint 95972081 Notice D'emploi

Operating Instruction

3.1.2 Start screen

Press the Power button to switch on the ap-
pliance. The following start screen appears.
12.64V
Fig. 5 Start screen
NOTE
In the lower left area of the start
screen, the current state of the in-
ternal 9 V block battery is displayed
.
Replace the battery promptly if
required in order to prevent the
appliance functions from being
impaired.
The voltage which is present at the battery
pole pliers is displayed in the lower cen-
tral area of the start screen. The "voltmeter
function" is activated by default and can be
deactivated if required (see Section "Basic
settings").
If the voltmeter display is activated, the start
screen will continue to be displayed and will
not be skipped until the OK button (for the
battery test) or the Menu button (for the Set-
tings menu) are pressed.
If the voltmeter display is deactivated, the
start screen (see Fig. 6) is displayed for 2 sec-
onds and then automatically skips forward
to the battery test. Press the Menu button
29
within 2 seconds if you wish to open the Set-
tings menu.
12.64V
Fig. 6 Start screen
CAUTION
The measuring range of the volt-
meter is 1-30 VDC.
A higher voltage than this would
destroy the appliance.

3.2 Basic settings

Press the Menu button (see Section "Start
screen") to proceed to the selection of the
individual options.

3.2.1 View results

Using this option, the last test result can be
displayed by pressing the OK button.
OPTIONS
1 VIEW RESULTS
95972081
EN